« Previous AbstractUnderwater mass spectrometers for in situ chemical analysis of the hydrosphere    Next AbstractA review on the advanced leachate treatment technologies and their performance comparison: an opportunity to keep the environment safe »

Rapid Commun Mass Spectrom

Title:		"Online methodology for determining compound-specific hydrogen stable isotope ratios of trichloroethene and 1,2-cis-dichloroethene by continuous-flow isotope ratio mass spectrometry"
Author(s):		Shouakar-Stash O; Drimmie RJ;
Address:		"Department of Earth and Environmental Sciences, University of Waterloo, 200 University Ave. West, Waterloo, Ontario, Canada, N2L 3G1. orfan@uwaterloo.ca"
Journal Title:		Rapid Commun Mass Spectrom
Year:		2013
Volume:		27
Issue:		12
Page Number:		1335 - 1344
DOI:		10.1002/rcm.6578
ISSN/ISBN:		1097-0231 (Electronic) 0951-4198 (Linking)
Abstract:		"RATIONALE: Carbon and chlorine compound-specific isotope analysis (CSIA) is utilized in chlorinated solvent contamination studies of soil and groundwater contaminated sites. However, in field studies, hydrogen CSIA has been used only in non-chlorinated volatile organic compound (VOC) investigations, due to low conversion yields into hydrogen gas and poor reproducibility. Therefore, it is important to develop hydrogen CSIA methodology for soil and subsurface contamination studies. METHODS: A new analytical method for determining compound-specific hydrogen stable isotope ratios is presented. The isotopic ratios were measured by gas chromatography/isotope ratio mass spectrometry (GC/IRMS) coupled with a chromium reduction system. The method was used to determine the delta(2) H values of trichloroethene (TCE) and 1,2-cis-dichloroethene (cis-DCE). RESULTS: The accuracy of the method was verified by conducting comparison measurements of standards by the conventional offline technique and the new method. The precision of the new analytical method (better than +/-7 per thousand) is better than that obtained from the offline method. The quantification limits of the headspace-solid-phase microextraction (SPME) are 400 microg/L and 200 microg/L for TCE and cis-DCE, respectively. The quantification limits can be improved by adopting a more efficient pre-concentration system such as purge-and-trap or thermal adsorption. CONCLUSIONS: This analytical method will facilitate the use of hydrogen CSIA on chlorinated solvents, which can be beneficial in multi-isotope approaches (coupling delta(2)H values with delta(13)C and/or delta(37)Cl values) in field site investigations where source identifications and contaminant behaviours are questioned"
Keywords:
Notes:		"PubMed-not-MEDLINEShouakar-Stash, Orfan Drimmie, Robert J eng England 2013/05/18 Rapid Commun Mass Spectrom. 2013 Jun 30; 27(12):1335-44. doi: 10.1002/rcm.6578"