Bedoukian   RussellIPM   RussellIPM   Piezoelectric Micro-Sprayer


Home
Animal Taxa
Plant Taxa
Semiochemicals
Floral Compounds
Semiochemical Detail
Semiochemicals & Taxa
Synthesis
Control
Invasive spp.
References

Abstract

Guide

Alphascents
Pherobio
InsectScience
E-Econex
Counterpart-Semiochemicals
Print
Email to a Friend
Kindly Donate for The Pherobase

« Previous AbstractFunctional expression of olfactory receptors in yeast and development of a bioassay for odorant screening    Next AbstractElectroantennogram responses of two tortricid moths using two-component sex pheromones »

ACS Omega


Title:Impact of Oxygen Functional Groups on Reduced Graphene Oxide-Based Sensors for Ammonia and Toluene Detection at Room Temperature
Author(s):Minitha CR; Anithaa VS; Subramaniam V; Rajendra Kumar RT;
Address:"Advanced Materials and Devices Laboratory (AMDL), Department of Physics, Department of Physics, Department of Medical Physics, and Department of Nanoscience and Technology, Bharathiar University, Coimbatore 641 046, India"
Journal Title:ACS Omega
Year:2018
Volume:20180412
Issue:4
Page Number:4105 - 4112
DOI: 10.1021/acsomega.7b02085
ISSN/ISBN:2470-1343 (Electronic) 2470-1343 (Linking)
Abstract:"The chemically reduced graphene oxide (rGO) was prepared by the reduction of graphene oxide by hydrazine hydrate. By varying the reduction time (10 min, 1 h, and 15 h), oxygen functional groups on rGO were tremendously controlled and they were named RG1, RG2, and RG3, respectively. Here, we investigate the impact of oxygen functional groups on the detection of ammonia and toluene at room temperature. Their effect on sensing mechanism was analyzed by first-principles calculation-based density functional theory. The sensing material was fabricated, and the effect of reduction time shown improved the recovery of ammonia and toluene sensing at room temperature. Structural, morphological, and electrical characterizations were performed on both RG1 and RG3. The sensor response toward toluene vapor of 300 ppm was found to vary 4.4, 2.5, and 3.8% for RG1, RG2, and RG3, respectively. Though RG1 shows higher sensing response with poor recovery, RG3 exhibited complete desorption of toluene after the sensing process with response and recovery times of approximately 40 and 75 s, respectively. The complete recovery of toluene molecules on RG3 is due to the generation of new sites after the reduction of oxygen functionalities on its surface. It could be suggested that these sites provided anchor to ammonia and toluene molecules and good recovery under N(2) purge. Both theoretical and experimental studies revealed that tuning the oxygen functional groups on rGO could play a vital role in the detection of volatile organic compounds (VOCs) on rGO sheets and was discussed in detail. This study could provoke knowledge about rGO-based sensor dependency with oxygen functional groups and shed light on effective monitoring of VOCs under ambient conditions for air quality monitoring applications"
Keywords:
Notes:"PubMed-not-MEDLINEMinitha, Cherukutty Ramakrishnan Anithaa, Velunair Sukumaran Subramaniam, Vijayakumar Rajendra Kumar, Ramasamy Thangavelu eng 2018/04/12 ACS Omega. 2018 Apr 12; 3(4):4105-4112. doi: 10.1021/acsomega.7b02085. eCollection 2018 Apr 30"

 
Back to top
 
Citation: El-Sayed AM 2024. The Pherobase: Database of Pheromones and Semiochemicals. <http://www.pherobase.com>.
© 2003-2024 The Pherobase - Extensive Database of Pheromones and Semiochemicals. Ashraf M. El-Sayed.
Page created on 26-12-2024