Bedoukian   RussellIPM   RussellIPM   Piezoelectric Micro-Sprayer


Home
Animal Taxa
Plant Taxa
Semiochemicals
Floral Compounds
Semiochemical Detail
Semiochemicals & Taxa
Synthesis
Control
Invasive spp.
References

Abstract

Guide

Alphascents
Pherobio
InsectScience
E-Econex
Counterpart-Semiochemicals
Print
Email to a Friend
Kindly Donate for The Pherobase

« Previous AbstractThresholds and the resilience of Caribbean coral reefs    Next AbstractThe significance of background odour for an egg parasitoid to detect plants with host eggs »

J Contam Hydrol


Title:Removal of trichloroethene from thin clay lenses by electrical resistance heating: Laboratory experiments and the effects of gas saturation
Author(s):Mumford KG; Martin EJ; Kueper BH;
Address:"Queen's University, Department of Civil Engineering, Kingston, Ontario K7L 3N6, Canada. Electronic address: kevin.mumford@queensu.ca. Queen's University, Department of Civil Engineering, Kingston, Ontario K7L 3N6, Canada"
Journal Title:J Contam Hydrol
Year:2021
Volume:20210925
Issue:
Page Number:103892 -
DOI: 10.1016/j.jconhyd.2021.103892
ISSN/ISBN:1873-6009 (Electronic) 0169-7722 (Linking)
Abstract:"The removal of dissolved volatile organic compounds (VOCs) from low-permeability lenses is important to limit back diffusion at sites impacted by dense non-aqueous phase liquids (DNAPLs). In situ thermal treatment (ISTT) technologies have the potential to treat DNAPL-impacted sites by enhancing diffusion from low-permeability lenses during heating. A series of two-dimensional laboratory tank experiments was conducted to investigate heating, gas formation, and trichloroethene (TCE) removal from a clay lens surrounded by sand. Results showed preferential heating of the clay and substantial TCE removal, with post-heating relative concentrations less than 0.06. The extent of TCE removal was not explained by only an increase in the aqueous TCE diffusion coefficient with increased temperature. Modelling estimates based on 1D diffusion from the lens showed that diffusion through both gas and water phases was required to match observations. Gas formation in the interior of the lens was also indicated by measured changes in bulk electrical conductivity of the clay during cool down, with gas saturations estimated to be greater than 0.21 at the end of heating. These estimates were larger than those needed to match the observed removal by diffusion, and suggest that connected gas pathways were created in the lens during heating, but that not all of the gas produced was part of those pathways. These results suggest that ISTT technologies may be effective in removing dissolved VOCs from thin clay lenses, and that gas formation within the clay should be considered when predicting the extent and rate of removal"
Keywords:"Clay Electric Impedance Heating Laboratories *Trichloroethylene/analysis *Water Pollutants, Chemical/analysis;"
Notes:"MedlineMumford, Kevin G Martin, Eric J Kueper, Bernard H eng Netherlands 2021/10/12 J Contam Hydrol. 2021 Dec; 243:103892. doi: 10.1016/j.jconhyd.2021.103892. Epub 2021 Sep 25"

 
Back to top
 
Citation: El-Sayed AM 2024. The Pherobase: Database of Pheromones and Semiochemicals. <http://www.pherobase.com>.
© 2003-2024 The Pherobase - Extensive Database of Pheromones and Semiochemicals. Ashraf M. El-Sayed.
Page created on 05-12-2024