| Title: | Use of chloroflurocarbons as internal standards for the measurement of atmospheric non-methane volatile organic compounds sampled onto solid adsorbent cartridges |
| Author(s): | Karbiwnyk CM; Mills CS; Helmig D; Birks JW; |
| Address: | "Department of Chemistry and Biochemistry and Cooperative Institute for Research in Environmental Sciences (CIBS), University of Colorado, Boulder, Colorado 80309-0216, USA" |
| ISSN/ISBN: | 0013-936X (Print) 0013-936X (Linking) |
| Abstract: | "Solid adsorbents have proven useful for determining the vertical profiles of volatile organic compounds (VOCs) using sampling platforms such as balloons, kites, and light aircraft, and those profiles provide valuable information about the sources, sinks, transformations, and transport of atmospheric VOCs. One of the largest contributions to error in VOC concentrations is the estimation of the volume of air sampled on the adsorbent cartridge. These errors arise from different sources, such as variations in pumping flow rates from changes in ambient temperature and pressure with altitude, and decrease in the sampling pump battery power. Another significant source for sampling rate variations are differences in the flow resistance of individual sampling cartridges. To improve the accuracy and precision of VOC measurements, the use of ambient chlorofluorocarbons (CFCs) as internal standards was investigated. A multibed solid adsorbent, AirToxic (Supelco), was chosen for its wide sampling range (C3-C12). Analysis was accomplished by thermal desorption and dual detection GC/FID/ECD, resulting in sensitive and selective detection of both VOCs and CFCs in the same sample. Long-lived chlorinated compounds (CFC-11, CFC-12, CFC-113, CCl4 and CH3CCl3) banned by the Montreal Protocol and subsequent amendments were studied for their ability to predict sample volumes using both ground-based and vertical profiling platforms through the boundary layer and free troposphere. Of these compounds, CFC-113 and CCl4 were found to yield the greatest accuracy and precision for sampling volume determination. Use of ambient CFC-113 and CCl4 as internal standards resulted in accuracy and precision of generally better than 10% for the prediction of sample volumes in ground-, balloon-, and aircraft-based measurements. Consequently, use of CFCs as reference compounds can yield a significant improvement of accuracy and precision for ambient VOC measurements in situations where accurate flow control is troublesome" |
| Keywords: | Adsorption Air Pollutants/*analysis Chlorofluorocarbons/*analysis Organic Chemicals/analysis Reference Values Reproducibility of Results Sensitivity and Specificity Volatilization; |
| Notes: | "MedlineKarbiwnyk, Christine M Mills, Craig S Helmig, Detlev Birks, John W eng Research Support, U.S. Gov't, Non-P.H.S. 2003/04/02 Environ Sci Technol. 2003 Mar 1; 37(5):1002-7. doi: 10.1021/es025910q" |
