Bedoukian   RussellIPM   RussellIPM   Piezoelectric Micro-Sprayer


Home
Animal Taxa
Plant Taxa
Semiochemicals
Floral Compounds
Semiochemical Detail
Semiochemicals & Taxa
Synthesis
Control
Invasive spp.
References

Abstract

Guide

Alphascents
Pherobio
InsectScience
E-Econex
Counterpart-Semiochemicals
Print
Email to a Friend
Kindly Donate for The Pherobase

« Previous AbstractFlorally rich habitats reduce insect pollination and the reproductive success of isolated plants    Next AbstractEmissions of volatile organic compounds from polymer-based consumer products: Comparison of three emission chamber sizes »

Front Public Health


Title:Emissions of VOCs From Polymer-Based Consumer Products: From Emission Data of Real Samples to the Assessment of Inhalation Exposure
Author(s):Even M; Girard M; Rich A; Hutzler C; Luch A;
Address:"Department of Chemical and Product Safety, German Federal Institute for Risk Assessment (BfR), Berlin, Germany"
Journal Title:Front Public Health
Year:2019
Volume:20190814
Issue:
Page Number:202 -
DOI: 10.3389/fpubh.2019.00202
ISSN/ISBN:2296-2565 (Print) 2296-2565 (Electronic) 2296-2565 (Linking)
Abstract:"The development of consumerism led to an increase in toy production. Such consumer products may contain non-intentionally added toxic substances that can emit from the product and may be inhaled by the consumer. Little data is available on the inhalation exposure of humans to volatile organic compounds (VOCs) from consumer products, so a reliable exposure assessment is needed. Only the emission chamber technique developed for building material emissions can provide solid estimations as it allows the products to be studied under real room conditions. This paper proposes a strategy to interpret emission experiment results from consumer products and assess the corresponding potential risk. It focuses on 14 common VOCs. The identification of the polymer type of 41 plastic articles was first performed by pyrolysis coupled online to gas chromatography with mass spectrometric detection (pyr-GC/MS). Their VOC profile was also determined by Dynamic Headspace-GC/MS (DHS-GC/MS). Softer polymers caused higher and broader emission profiles. Four specific toy samples were selected to be studied in a 203 l emission chamber and their emissions were compared to a reference material. A rapid decrease in the emissions was observed for each product and VOC. Based on these emission curves over time, the corresponding indoor air concentration could be calculated for the target VOCs for short-term or long-term exposures. The indoor air levels obtained were at least 35 times lower than the levels according to conventional indoor air guidelines. Guideline values were only exceeded using very conservative exposure scenarios"
Keywords:VOCs consumer emission exposure polymers toys;
Notes:"PubMed-not-MEDLINEEven, Morgane Girard, Mathilde Rich, Anna Hutzler, Christoph Luch, Andreas eng Switzerland 2019/09/03 Front Public Health. 2019 Aug 14; 7:202. doi: 10.3389/fpubh.2019.00202. eCollection 2019"

 
Back to top
 
Citation: El-Sayed AM 2024. The Pherobase: Database of Pheromones and Semiochemicals. <http://www.pherobase.com>.
© 2003-2024 The Pherobase - Extensive Database of Pheromones and Semiochemicals. Ashraf M. El-Sayed.
Page created on 27-11-2024