| Title: | Dilution-based emissions sampling from stationary sources: Part 2--Gas-fired combustors compared with other fuel-fired systems |
| Author(s): | England GC; Watson JG; Chow JC; Zielinska B; Chang MC; Loos KR; Hidy GM; |
| Address: | "Environmental Services Business Unit, GE Energy, Santa Ana, CA, USA" |
| DOI: | 10.1080/10473289.2007.10465304 |
| ISSN/ISBN: | 1096-2247 (Print) 1096-2247 (Linking) |
| Abstract: | "With the recent focus on fine particle matter (PM2.5), new, self-consistent data are needed to characterize emissions from combustion sources. Such data are necessary for health assessment and air quality modeling. To address this need, emissions data for gas-fired combustors are presented here, using dilution sampling as the reference. The dilution method allows for collection of emitted particles under conditions simulating cooling and dilution during entry from the stack into the air. The sampling and analysis of the collected particles in the presence of precursor gases, SO2 nitrogen oxide, volatile organic compound, and NH3 is discussed; the results include data from eight gas fired units, including a dual-fuel institutional boiler and a diesel engine powered electricity generator. These data are compared with results in the literature for heavy-duty diesel vehicles and stationary sources using coal or wood as fuels. The results show that the gas-fired combustors have very low PM2.5 mass emission rates in the range of approximately 10(-4) lb/million Btu (MMBTU) compared with the diesel backup generator with particle filter, with approximately 5 x 10(-3) lb/MMBTU. Even higher mass emission rates are found in coal-fired systems, with rates of approximately 0.07 lb/MMBTU for a bag-filter-controlled pilot unit burning eastern bituminous coal. The characterization of PM2.5 chemical composition from the gas-fired units indicates that much of the measured primary particle mass in PM2.5 samples is organic or elemental carbon and, to a much less extent, sulfate. Metal emissions are quite low compared with the diesel engines and the coal- or wood-fueled combustors. The metals found in the gas-fired combustor particles are low in concentration, similar in concentration to ambient particles. The interpretation of the particulate carbon emissions is complicated by the fact that an approximately equal amount of particulate carbon (mainly organic carbon) is found on the particle collector and a backup filter. It is likely that measurement artifacts, mostly adsorption of volatile organic compounds on quartz filters, are positively biasing 'true' particulate carbon emission results" |
| Keywords: | "Air Pollutants, Occupational/*analysis Air Pollution/*analysis Environmental Monitoring/*methods *Fossil Fuels *Fuel Oils Gasoline Industrial Waste/*analysis;" |
| Notes: | "MedlineEngland, Glenn C Watson, John G Chow, Judith C Zielinska, Barbara Chang, M C Oliver Loos, Karl R Hidy, George M eng Comparative Study Research Support, Non-U.S. Gov't Research Support, U.S. Gov't, Non-P.H.S. 2007/02/03 J Air Waste Manag Assoc. 2007 Jan; 57(1):79-93. doi: 10.1080/10473289.2007.10465304" |
