Bedoukian   RussellIPM   RussellIPM   Piezoelectric Micro-Sprayer


Home
Animal Taxa
Plant Taxa
Semiochemicals
Floral Compounds
Semiochemical Detail
Semiochemicals & Taxa
Synthesis
Control
Invasive spp.
References

Abstract

Guide

Alphascents
Pherobio
InsectScience
E-Econex
Counterpart-Semiochemicals
Print
Email to a Friend
Kindly Donate for The Pherobase

« Previous Abstract"Monitoring of polyaromatic hydrocarbons and volatile organic compounds in two major traffic tunnels in Seoul, Korea"    Next AbstractAn exploration on the suitability of airborne carbonyl compounds analysis in relation to differences in instrumentation (GC-MS versus HPLC-UV) and standard phases (gas versus liquid) »

Anal Bioanal Chem


Title:Conditions for the optimal analysis of volatile organic compounds in air with sorbent tube sampling and liquid standard calibration: demonstration of solvent effect
Author(s):Kim KH; Kim YH; Brown RJ;
Address:"Department of Environment & Energy, Sejong University, Seoul, 143-747, South Korea, kkim61@nate.com"
Journal Title:Anal Bioanal Chem
Year:2013
Volume:20130802
Issue:26
Page Number:8397 - 8408
DOI: 10.1007/s00216-013-7263-9
ISSN/ISBN:1618-2650 (Electronic) 1618-2642 (Linking)
Abstract:"The combined use of sorbent tubes (ST) and thermal desorption (TD) has become the common practice for the trace-level analysis of gaseous volatile organic compounds (VOCs). In this research, the potential bias in VOC analysis due to the solvent introduced into the system as a liquid standard (LS) is examined in three stages by analyzing LSs of 19 VOCs in methanol solvent against a three-bed ST (Tenax TA, Carbopack B, and Carboxen 1000). In experimental stage 1, LS made at four concentration levels (between 10 and 150 ng muL(-1)) were each analyzed at four injection volumes (1, 2, 5, and 10 muL) based on a vaporization method. In experimental stage 2, calibration was also conducted by direct injection over an extended concentration range at two volumes, 1 and 10 muL. In experimental stage 3, the response factors (RF) of a single analyte mass were compared across the four injection volumes and between two injection methods. These results were analyzed to explore the complex relationship between variables such as LS volume, target/solvent chemical type, sorbent strength, and prepurge condition. There was no change in the ST/TD performance up to 2 muL of LS. However, as the injection volume increased up to 5 muL, a notable shift in RF and retention time occurred (e.g., for benzene and methyl ethyl ketone). At the maximum injection volume (10 muL), a significant reduction in sensitivity is evident for all compounds, e.g., 50 % drops relative to 1 muL injection. As such, the TD performance tends to deteriorate with increasing volume of methanol initially loaded on the ST. Although the dominant fraction of solvent was removed by two prepurge steps, residue caught in the strong sorbent fraction is still found to exert an effect on the subsequent analysis, e.g., delayed retention, sensitivity reduction, or disappearance of certain compounds"
Keywords:
Notes:"PubMed-not-MEDLINEKim, Ki-Hyun Kim, Yong-Hyun Brown, Richard J C eng Germany 2013/08/03 Anal Bioanal Chem. 2013 Oct; 405(26):8397-408. doi: 10.1007/s00216-013-7263-9. Epub 2013 Aug 2"

 
Back to top
 
Citation: El-Sayed AM 2024. The Pherobase: Database of Pheromones and Semiochemicals. <http://www.pherobase.com>.
© 2003-2024 The Pherobase - Extensive Database of Pheromones and Semiochemicals. Ashraf M. El-Sayed.
Page created on 23-11-2024