Bedoukian   RussellIPM   RussellIPM   Piezoelectric Micro-Sprayer


Home
Animal Taxa
Plant Taxa
Semiochemicals
Floral Compounds
Semiochemical Detail
Semiochemicals & Taxa
Synthesis
Control
Invasive spp.
References

Abstract

Guide

Alphascents
Pherobio
InsectScience
E-Econex
Counterpart-Semiochemicals
Print
Email to a Friend
Kindly Donate for The Pherobase

« Previous AbstractChemical constituents in particulate emissions from an integrated iron and steel facility    Next AbstractAtmospheric concentrations and fluxes of organic compounds in the northern San Francisco Estuary »

J Environ Sci Health A Tox Hazard Subst Environ Eng


Title:Concentration characteristics of VOCs and acids/bases in the gas phase and water-soluble ions in the particle phase at an electrical industry park during construction and mass production
Author(s):Tsai JH; Huang YS; Shieh ZX; Chiang HL;
Address:"Department of Environmental Engineering, Sustainable Environmental Research Center, National Cheng-Kung University, Tainan, Taiwan"
Journal Title:J Environ Sci Health A Tox Hazard Subst Environ Eng
Year:2011
Volume:46
Issue:5
Page Number:540 - 551
DOI: 10.1080/10934529.2011.551747
ISSN/ISBN:1532-4117 (Electronic) 1093-4529 (Linking)
Abstract:"The electronics industry is a major business in the Central Taiwan Science Park (CTSP). Particulate samples and 11 water-soluble ionic species in the particulate phase were measured by ionic chromatography (IC). Additionally, acid and base gases were sampled by denuder absorption and analyzed by IC. Volatile organic compounds (VOCs) were collected in stainless-steel canisters four times daily and analyzed via gas chromatography/mass spectrometry. Ozone formation potential (OFP) was measured using maximum increment reactivity. In addition, airborne pollutants during (1) construction and (2) mass production were measured. Particulate matter concentration did not increase significantly near the optoelectronic plant during construction, but it was higher than during mass production. SO(2), HNO(2) and NH(3) were the dominant gases in the denuder absorption system. Nitrate, sulfate, and ammonium ions predominated both in PM(2.5) and PM(10-2.5); but calcium ion concentration was significantly higher in PM(10-2.5) samples during construction. Toluene, propane, isopentane, and n-butane may have come from vehicle exhaust. Construction equipment emitted high concentrations of ethylbenzene, m-xylene, p-xylene, o-xylene, 1,2,4-trimethylbenzene, and toluene. During mass production, methyl ethyl ketone), acetone and ethyl acetate were significantly higher than during construction, although there was continuous rain. The aromatic group constituted >50% of the VOC concentration totals and contributed >70% of OFP"
Keywords:Air Pollutants/*analysis *Environmental Monitoring Gas Chromatography-Mass Spectrometry Gases/*analysis Industrial Waste/analysis Particulate Matter/analysis Taiwan Vehicle Emissions/analysis Volatile Organic Compounds/*analysis;
Notes:"MedlineTsai, Jiun H Huang, Yao S Shieh, Zhu X Chiang, Hung L eng Research Support, Non-U.S. Gov't England 2011/04/07 J Environ Sci Health A Tox Hazard Subst Environ Eng. 2011; 46(5):540-51. doi: 10.1080/10934529.2011.551747"

 
Back to top
 
Citation: El-Sayed AM 2024. The Pherobase: Database of Pheromones and Semiochemicals. <http://www.pherobase.com>.
© 2003-2024 The Pherobase - Extensive Database of Pheromones and Semiochemicals. Ashraf M. El-Sayed.
Page created on 03-07-2024