Bedoukian   RussellIPM   RussellIPM   Piezoelectric Micro-Sprayer


Home
Animal Taxa
Plant Taxa
Semiochemicals
Floral Compounds
Semiochemical Detail
Semiochemicals & Taxa
Synthesis
Control
Invasive spp.
References

Abstract

Guide

Alphascents
Pherobio
InsectScience
E-Econex
Counterpart-Semiochemicals
Print
Email to a Friend
Kindly Donate for The Pherobase

« Previous AbstractA pheromone-independent CarR protein controls carbapenem antibiotic synthesis in the opportunistic human pathogen Serratia marcescens    Next AbstractUse of direct headspace-mass spectrometry coupled with chemometrics to predict aroma properties in Australian Riesling wine »

Environ Sci Technol


Title:Predicting the emission rate of volatile organic compounds from vinyl flooring
Author(s):Cox SS; Little JC; Hodgson AT;
Address:"Virginia Polytechnic Institute & State University, Blacksburg 24061, USA"
Journal Title:Environ Sci Technol
Year:2002
Volume:36
Issue:4
Page Number:709 - 714
DOI: 10.1021/es010802+
ISSN/ISBN:0013-936X (Print) 0013-936X (Linking)
Abstract:"A model for predicting the rate at which a volatile organic compound (VOC) is emitted from a diffusion-controlled material is validated for three contaminants (n-pentadecane, n-tetradecane, and phenol) found in vinyl flooring (VF). Model parameters are the initial VOC concentration in the material phase (C0), the material/air partition coefficient (K), and the material-phase diffusion coefficient (D). The model was verified by comparing predicted gas-phase concentrations to data obtained during small-scale chamber tests and by comparing predicted material-phase concentrations to those measured at the conclusion of the chamber tests. Chamber tests were conducted with the VF placed top-side-up and bottom-side-up. With the exception of phenol and within the limits of experimental precision, the mass of VOCs recovered in the gas-phase balances the mass emitted from the material phase. The model parameters (C0, K, and D) were measured using procedures completely independent of the chamber test. Gas- and material-phase predictions compare well to the bottom-side-up chamber data. The lower emission rates for the top-side-up orientation may be explained by the presence of a low-permeability surface layer. The sink effect of the stainless steel chamber surface was shown to be negligible"
Keywords:"Air Pollution, Indoor/*analysis Alkanes/analysis/chemistry *Floors and Floorcoverings Forecasting Organic Chemicals Phenol/analysis/chemistry Vinyl Compounds/*chemistry Volatilization;"
Notes:"MedlineCox, Steven S Little, John C Hodgson, Alfred T eng Research Support, U.S. Gov't, Non-P.H.S. 2002/03/07 Environ Sci Technol. 2002 Feb 15; 36(4):709-14. doi: 10.1021/es010802+"

 
Back to top
 
Citation: El-Sayed AM 2024. The Pherobase: Database of Pheromones and Semiochemicals. <http://www.pherobase.com>.
© 2003-2024 The Pherobase - Extensive Database of Pheromones and Semiochemicals. Ashraf M. El-Sayed.
Page created on 22-11-2024