Bedoukian   RussellIPM   RussellIPM   Piezoelectric Micro-Sprayer


Home
Animal Taxa
Plant Taxa
Semiochemicals
Floral Compounds
Semiochemical Detail
Semiochemicals & Taxa
Synthesis
Control
Invasive spp.
References

Abstract

Guide

Alphascents
Pherobio
InsectScience
E-Econex
Counterpart-Semiochemicals
Print
Email to a Friend
Kindly Donate for The Pherobase

« Previous AbstractInvestigation of the characteristics of biofilms grown in gas-phase biofilters with and without ozone injection by CLSM technique    Next AbstractCharacterizing the sorption of polybrominated diphenyl ethers (PBDEs) to cotton and polyester fabrics under controlled conditions »

J Environ Sci (China)


Title:Effect of ozone injection on the long-term performance and microbial community structure of a VOCs biofilter
Author(s):Saingam P; Baig Z; Xu Y; Xi J;
Address:"Environmental Simulation and Pollution Control State Key Joint Laboratory, School of Environment, Tsinghua University, Beijing 100084, China. Environmental Simulation and Pollution Control State Key Joint Laboratory, School of Environment, Tsinghua University, Beijing 100084, China; Key Laboratory of Microorganism Application and Risk Control of Shenzhen, Graduate School at Shenzhen, Tsinghua University, Shenzhen 518055, China. Electronic address: xijinying@tsinghua.edu.cn"
Journal Title:J Environ Sci (China)
Year:2018
Volume:20170923
Issue:
Page Number:133 - 140
DOI: 10.1016/j.jes.2017.09.008
ISSN/ISBN:1001-0742 (Print) 1001-0742 (Linking)
Abstract:"For biofilters treating waste gases containing volatile organic compounds (VOCs), biomass accumulation is a common problem which will induce bed clogging and significant decrease in VOCs removal efficiency during long-term operation. In this study, ozone injection was developed as a biomass control strategy, and its effects on the biofilter performance and the microbial community structure were investigated in long-term operation. Two biofilters, identified as BF1 and BF2, were operated continuously for 160?ª+days treating gaseous toluene under the same conditions, except that 200?ª+mg/m(3) ozone was continuously injected into BF1 during days 45-160. During the operation period, ozone injection did not change the toluene removal efficiency, while the pressure drop of BF1 with ozone injection was significantly lowered compared with BF2. The wet biomass accumulation rate of BF1 was 11?ª+g/m(3)/hr, which was only 46% of that in BF2. According to the carbon balance result, ozone injection also increased the toluene mineralization rate from 83% to 91%, which could be an important reason for the low biomass accumulation. The PMA-qPCR result indicated that ozone injection increased the microbial viability of the biofilm. The high-throughput sequencing result also revealed that the dominant phyla and genera were not changed significantly by ozone injection, but some ozone-tolerant genera such as Rhodanobacter, Dokdonella and Rhodococcus were enhanced by ozone exposure. All the results verified that ozone injection is capable of sustaining the long-term performance of biofilters by lowering the biomass accumulation, increasing the microbial viability and changing the microbial community structure"
Keywords:"Air Pollutants/analysis/*toxicity Air Pollution/prevention & control Biodegradation, Environmental Biofilms Biomass Bioreactors/*microbiology Ozone/*toxicity Toluene/analysis Volatile Organic Compounds/analysis Waste Disposal, Fluid/*methods Biofilter Bio;"
Notes:"MedlineSaingam, Prakit Baig, Zenab Xu, Yang Xi, Jinying eng Netherlands 2018/06/27 J Environ Sci (China). 2018 Jul; 69:133-140. doi: 10.1016/j.jes.2017.09.008. Epub 2017 Sep 23"

 
Back to top
 
Citation: El-Sayed AM 2024. The Pherobase: Database of Pheromones and Semiochemicals. <http://www.pherobase.com>.
© 2003-2024 The Pherobase - Extensive Database of Pheromones and Semiochemicals. Ashraf M. El-Sayed.
Page created on 22-11-2024