| Title: | Influence of polymer additives on gas-phase emissions from 3D printer filaments |
| Author(s): | Potter PM; Al-Abed SR; Hasan F; Lomnicki SM; |
| Address: | "Oak Ridge Institute for Science and Education (ORISE), EPA, Cincinnati, OH, 45268, USA. Center for Environmental Solutions and Emergency Response (CESER), EPA, Cincinnati, OH, 45268, USA. Electronic address: al-abed.souhail@epa.gov. Department of Environmental Sciences, Louisiana State University, Baton Rouge, LA, 70803, USA" |
| DOI: | 10.1016/j.chemosphere.2021.130543 |
| ISSN/ISBN: | 1879-1298 (Electronic) 0045-6535 (Print) 0045-6535 (Linking) |
| Abstract: | "A collection of six commercially available, 3D printer filaments were analyzed with respect to their gas-phase emissions, specifically volatile organic compounds (VOCs), during simulated fused filament fabrication (FFF). Filaments were chosen because they were advertised to contain metal particles or carbon nanotubes. During experimentation, some were found to contain other non-advertised additives that greatly influenced gas-phase emissions. Three polylactic acid (PLA) filaments containing either copper, bronze, or stainless steel particles were studied along in addition to three carbon nanotube (CNT) filaments made from PLA, acrylonitrile-butadiene-styrene (ABS), and polycarbonate (PC). The metal-additive PLA filaments were found to emit primarily lactide, acetaldehyde, and 1-chlorododecane. The presence of metal particles in the PLA is a possible cause of the increased total emissions, which were higher than any other PLA filament reported in the literature. In addition, the filament with stainless steel particles had a threefold increase in total VOCs compared to the copper and bronze particles. Two of three CNT-containing filaments emitted compounds that have not been reported before for PLA and PC. A comparison between certain emitted VOCs and their suggested maximum inhalation limits shows that printing as little as 20 g of certain filaments in a small, unventilated room can subject the user to hazardous concentrations of multiple toxic VOCs with carcinogenic properties (e.g., acetaldehyde, 1,4-dioxane, and bis(2-ethylhexyl) phthalate). The use of certain additives, whether advertised or not, should be reevaluated due to their effects on VOC emissions during 3D printing" |
| Keywords: | "*Air Pollution, Indoor/analysis *Nanotubes, Carbon Particulate Matter Polymers *Volatile Organic Compounds/analysis 3D printing Additive manufacturing Indoor air quality Polymer degradation VOCs Volatile organic compounds;" |
| Notes: | "MedlinePotter, Phillip M Al-Abed, Souhail R Hasan, Farhana Lomnicki, Slawomir M eng EPA999999/Intramural EPA/ England 2021/04/27 Chemosphere. 2021 Sep; 279:130543. doi: 10.1016/j.chemosphere.2021.130543. Epub 2021 Apr 15" |
