| Title: | Poly(3-Methylthiophene) Thin Films Deposited Electrochemically on QCMs for the Sensing of Volatile Organic Compounds |
| Author(s): | Ozturk S; Kosemen A; Sen Z; Kilinc N; Harbeck M; |
| Address: | "Faculty of Engineering, Fatih Sultan Mehmet Vakif University, Istanbul 34080, Turkey. sozturk@fsm.edu.tr. Department of Physics, Mus Alparslan University, Mus 49100, Turkey. akosemen@gtu.edu.tr. Science Faculty, Department of Physics, Gebze Technical University, Kocaeli 41400, Turkey. akosemen@gtu.edu.tr. Materials Institute, TUBITAK Marmara Research Center, Gebze 41470, Turkey. zafer.sen@tubitak.gov.tr. Mechatronics Engineering Department and Nanotechnology Application & Research Center, Nigde University, Nigde 51245, Turkey. nkilinc@nigde.edu.tr. Materials Institute, TUBITAK Marmara Research Center, Gebze 41470, Turkey. mika.harbeck@tubitak.gov.tr" |
| ISSN/ISBN: | 1424-8220 (Electronic) 1424-8220 (Linking) |
| Abstract: | "Poly(3-methylthiophene) (PMeT) thin films were electrochemically deposited on quartz crystal microbalance QCM transducers to investigate their volatile organic compound (VOC) sensing properties depending on ambient conditions. Twelve different VOCs including alcohols, ketones, chlorinated compounds, amines, and the organosphosphate dimethyl methylphosphonate (DMMP) were used as analytes. The responses of the chemical sensors against DMMP were the highest among the tested analytes; thus, fabricated chemical sensors based on PMeT can be evaluated as potential candidates for selectively detecting DMMP. Generally, detection limits in the low ppm range could be achieved. The gas sensing measurements were recorded at various humid air conditions to investigate the effects of the humidity on the gas sensing properties. The sensing performance of the chemical sensors was slightly reduced in the presence of humidity in ambient conditions. While a decrease in sensitivity was observed for humidity levels up to 50% r.h., the sensitivity was nearly unaffected for higher humidity levels and a reliable detection of the VOCs and DMMP was possible with detection limits in the low ppm range" |
| Keywords: | Dmmp Qcm VOCs chemical gas sensor electrochemical deposition humid air poly(3-methylthiophene); |
| Notes: | "PubMed-not-MEDLINEOzturk, Sadullah Kosemen, Arif Sen, Zafer Kilinc, Necmettin Harbeck, Mika eng Research Support, Non-U.S. Gov't Switzerland 2016/03/31 Sensors (Basel). 2016 Mar 23; 16(4):423. doi: 10.3390/s16040423" |
